Carburetor Tune Up Kit Fits John Deere Replaces KT-FSC30-0070

One New Aftermarket Carburetor Tune Up Kit

Tech Info:
-(1) Spark Plug Wiring Set
-90 Degree Boots
-Wires Are Approximately 32″ and 49″ Long
-Copper Core
-Aluminum Coating to Prevent Corrosion
-Neoprene Outer Cover
-Each Spark Plug Wire Has One End Pre-Assembled – Crimp the Other End With a Crimping Tool
-Coil Wire is the Excess Wire Left Over From the Spark Plug Wire
–
-(1) Distributor Cap
-Dim A (1) 2 Cyl. Vertical
-Dim B (2) Clip Type
–
-(1) Tune-Up Kit
-Contains: Breaker Points, Condenser, and Rotor
-Replaces Part Number: ATK1DCR
–
-(2) Spark Plug
-7/8″ – 18 Thread Diameter
-5/8″ Reach
-15/16″ Hex
-Cold Heat Range
-Standard Tip / Non-Resistor
-Replaces Part Number: AL3076
–
-(1) Distributor Dust Cover
-Includes Felt gasket, Washer, Ruber seal
–
-Please Note: Fits Delco Distributors with Clip-On Cap Only
-Replaces Part Number: 1900119
–
-(1) Economy Carburetor Kit
-Includes Gaskets, Needle, & Seat
-Replaces: R0069, 4022815
–
-(1) Carburetor Float
-For Large Bowl Marvel Schebler Carburetors
-Replaces Part Numbers: AM1613T, AM1794T, AM3061T, AM366T, AT10181T, AT11158T, AT11637T
–
-(1) Engine Oil Filter
-4-1/8″ Length
-3-5/16″ O.D.
-1.095″ Center Stud Hole Diameter
-Cartridge Type Filter
-Replaces Part Numbers: ABC217, AH1081R, AH812R

Made to Fit John Deere:
Tractor Models: 320, 330, 420, 430, 440 (2 CYLINDER), M, MC, MT, 40
Model Breaks: 440 (2 CYLINDER)Additional Information: (1) Spark Plug Wiring Set90 Degree BootsWires Are Approximately 32″ and 49″ LongCopper CoreAluminum Coating to Prevent CorrosionNeoprene Outer CoverEach Spark Plug Wire Has One End Pre-Assembled – Crimp the Other End With a Crimping ToolCoil Wire is the Excess Wire Left Over From the Spark Plug Wire(1) Distributor CapDim A (1) 2 Cyl. VerticalDim B (2) Clip Type(1) Tune-Up KitContains: Breaker Points, Condenser, and RotorReplaces Part Number: ATK1DCR(2) Spark Plug7/8″ – 18 Thread Diameter5/8″ Reach15/16″ HexCold Heat RangeStandard Tip / Non-ResistorReplaces Part Number: AL3076(1) Distributor Dust CoverIncludes Felt gasket, Washer, Ruber sealPlease Note: Fits Delco Distributors with Clip-On Cap OnlyReplaces Part Number: 1900119(1) Economy Carburetor KitIncludes Gaskets, Needle, & SeatReplaces: R0069, 4022815(1) Carburetor FloatFor Large Bowl Marvel Schebler CarburetorsReplaces Part Numbers: AM1613T, AM1794T, AM3061T, AM366T, AT10181T, AT11158T, AT11637T(1) Engine Oil Filter4-1/8″ Length3-5/16″ O.D.1.095″ Center Stud Hole DiameterCartridge Type FilterReplaces Part Numbers: ABC217, AH1081R, AH812R